- CHAINS OR SNOW TIRES ARE REQUIRED FROM 16 MI NORTH OF BISHOP TO 6 MI SOUTH OF THE JCT OF SR 203 (MONO CO)
- CHAINS ARE REQUIRED ON ALL VEHICLES EXCEPT 4-WHEEL-DRIVE VEHICLES WITH SNOW TIRES ON ALL 4 WHEELS FROM 6 MI SOUTH OF THE JCT OF SR 203 TO THE JCT OF JCT OF SR 203 (MONO CO)
- CHAINS OR SNOW TIRES ARE REQUIRED FROM THE SOUTH JCT OF SR 158 TO 7 MI NORTH OF LEE VINING (MONO CO)
- CHAINS ARE REQUIRED ON ALL VEHICLES EXCEPT 4-WHEEL-DRIVE VEHICLES WITH SNOW TIRES ON ALL 4 WHEELS FROM 7 MI NORTH OF LEE VINING TO 7 MI SOUTH OF BRIDGEPORT (MONO CO)
- CHAINS OR SNOW TIRES ARE REQUIRED FROM 7 MI SOUTH OF BRIDGEPORT (MONO CO) TO THE NEVADA STATE LINE
PLEASE RESEARCH CHAIN CONTROL LOCATIONS AS CALTRANS IS CURRENTLY WORKING TO UPDATE CHAIN CONTROL DESCRIPTIONS FOR CONSISTENCY WITH INTERNET MAPPING, LIKE GOOGLE MAPS & MAPQUEST.
– LARGE TRUCKS WITH SINGLE-AXLE-DRIVE TOWING TWO TRAILERS ARE PROHIBITED IN CHAIN CONTROL AREAS
Chain Requirement Levels
During the winter months, motorists may encounter traction chain controls in the mountain areas within California. When chain controls are established, signs will be posted along the road indicating the type of requirement. There are Three Levels of Chain Requirements in California:
- Requirement 1 (R-1): Chains are required on all vehicles except passenger vehicles and light-duty trucks under 6,000 pounds gross weight and equipped with snow tires on at least two drive wheels. Chains must be carried by vehicles using snow tires. All vehicles towing trailers must have chains on one drive axle. Trailers with brakes must have chains on at least one axle.
- Requirement 2 (R2): Chains or traction devices are required on all vehicles except four-wheel/all-wheel drive vehicles with snow-tread tires on all four wheels.
NOTE: (Four-wheel/all-wheel drive vehicles must carry traction devices in chain control areas.)
- Requirement 3 (R3): Chains or traction devices are required on all vehicles, no exceptions.
Truckers, see our Truck Chain Requirements page.
R-1 and R-2 are the most common conditions. A highway will often be closed before an R-3 condition is imposed. Some local areas may use variations of these designations. You must follow the directions on the signs posted for chain controls or any instructions given by Caltrans or CHP personnel at chain control check points, even if these are at variance with broadcast road condition reports or information contained herein.
1 Snow-tread Tires: The California Vehicle Code, Section 558 defines a snow-tread tire as follows, “A ‘Snow-tread tire’ is a tire which has a relatively deep and aggressive tread pattern compared with conventional passenger tread pattern”. Snow-tread tires can be identified by examining the sidewall of the tire where the letters MS, M/S, M+S or the words MUD AND SNOW have been stamped into the sidewall.
2 Tire Traction Devices: The California Vehicle Code, Section 605 defines tire traction devices as follows: “Tire Traction Devices are devices or mechanisms having a composition and design capable of improving vehicle traction, braking and cornering ability upon snow or ice-covered surfaces. Tire traction devices shall be constructed and assembled to provide sufficient structural integrity and to prevent accidental detachment from vehicles. Tire traction devices shall, at the time of manufacture or final assembly, bear a permanent impression indicating the name, initials or trademark of the assembling company or primary manufacturer, and the country in which the devices were manufactured or assembled in final form.”
The full, searchable version of the California Vehicle Code is available at: Leginfo, the website for California Legislative Information.
Please note: The California Department Of Transportation (Caltrans) reserves the right to prevent any vehicle from entering a chain control area when it is determined the vehicle will experience difficulty in safely traveling the area.